The little panel on the rear skins wasn't holding too well, I could push it out with my finger very easily. I decided to JB Weld it in from the back side.
I then went on to attach the large panel on the rear door. I again JB Welded this panel on to the door. After a while I checked to make sure the clamps did no adhere to the door.
Cal Poly Pomona College of Engineering presentation
                      -
                    
We were happy to bring an inspirational presentation to hundreds of bright 
young students at Cal Poly Pomona College of Engineering. Not even a fire 
alar...
4 weeks ago
 
 
 
 Posts
Posts
 
 
No comments:
Post a Comment